Door Frames and Doorways With Hybrid Flooring — How It's Finished Neatly
Quick answer: For the neatest finish, installers undercut the door frames (jambs and architraves) so the hybrid planks slide straight underneath. There's no scotia wrapped around the frame and no gap to see. In doorways, hybrid can often run straight through from room to room. Where it meets another floor, or where a big floor needs room to move, a slim colour-matched trim finishes the join. Our matching T-mouldings and reducers start from $13.64 per 2.4m length (supply only, ex GST, as at November 2026), and one length does two standard doorways.
Undercutting door frames: the clean finish
Instead of cutting the planks around the shape of the frame, the installer trims a thin slice off the bottom of each jamb and architrave, just the height of the new floor. The plank then tucks underneath.
Why it looks better: the floor appears to run under the frame, just like it was built that way.
No fiddly scotia around the frame: the frame itself hides the expansion gap.
Works on timber frames: a jamb saw makes a quick, clean cut.
Steel door frames: these can be neatly trimmed too, with the right tool, so planks slide underneath.

Running through doorways
One of the best things about hybrid is that it can flow from room to room in one continuous floor, so there's no line across every doorway. Your installer will check the size and shape of your rooms. On very large or oddly shaped areas, a slim T-moulding at a doorway gives the floor a little room to move. In a doorway it's barely noticed, and it's colour-matched to your floor.
Where hybrid meets another floor
Same height (like tiles at a similar level): a colour-matched T-moulding bridges the two floors neatly.
Stepping down (like to carpet or lower tiles): a reducer ramps gently from the hybrid down to the lower floor.
Against a sliding door track or step edge: an L-moulding or end cap gives a crisp, finished edge.
Our guide to flooring transition strips shows each trim and where it goes.
Doors that need a trim
New flooring can raise the floor height slightly. If a door now brushes the floor, the bottom of the door is trimmed a few millimetres so it swings freely. It's a quick job and part of a careful install.

What about the walls?
At the walls, hybrid needs a small gap so the floor can float. That's hidden by your skirting boards or a slim scotia trim (from $11.82 per 2.4m, ex GST). See do you remove skirting boards for new flooring for both options.
What does it cost for 60 m²?
For a typical 60 m² home area, order about 65 m² of planks to allow for cuts. In SPC hybrid from $26.01/m², that's about $1,691 supply only, ex GST, plus a few trims for doorways and walls. Our flooring calculator adds matching trims for you. Installed prices, including undercutting and trims, come from a free measure and written quote.
Next steps
Browse our SPC hybrid flooring, with colour-matched trims for every range.
Book a free measure and quote. We install in Coffs Harbour, Grafton, Yamba, Port Macquarie, Brisbane, the Gold Coast, Sydney and surrounding areas, and deliver Australia-wide.



Comments