top of page
Colour-matched T-moulding for hybrid flooring

ACCESSORIES · TRIMS & MOULDINGS

Flooring trims and mouldings

Floor trims and transition strips are the colour-matched pieces that finish the edges of a floating floor: where it meets carpet, tile or another hard floor, where it stops at a sliding door or a hearth, and at each stair. Get them right and the floor looks like it was always there; get them wrong and every doorway shows. Here's each trim, what it does, and how many you need.

The right trim for every edge

Four trims cover almost every doorway, step and edge in a home. Here is what each one does.

 

 

T-moulding joining two floors of the same height

T-moulding

Joins two floors of the same height, like a doorway between rooms.

Reducer trim stepping down from hybrid flooring to a lower floor

Reducer

Steps your new floor down to a lower one, like vinyl or concrete.

L-moulding end cap finishing a floor edge

L-moulding

Finishes a floor edge against tiles, a sliding door or a step.

Stair nosing finishing the edge of a step

Stair nosing

Protects and finishes the front edge of each step.

01

The four trims

And scotia, which covers the expansion gap along the walls.

02

HTT or Riverhill?

Match the trim brand to the floor brand so the colour is finished in the same print. HTT trims suit Guardian, Duro, Duro Opulence, Obsidian, MTF, TimberFlow, Hydrocore, AquaGlow and HTT engineered oak. Riverhill trims suit Elegant 6.5mm and 9.5mm, Urban laminate and Riverhill engineered timber. Pick your floor's colour on the trim's product page.

03

How many you need

T-mouldings, reducers and L-mouldings come in 2.4m lengths; a standard doorway is about 820mm, so one length does two doorways with offcut to spare. Count every doorway where the new floor meets a different floor, and every open edge. Stair nosing is one piece per step. The flooring calculator lists trims alongside your boxes.

04

Fitting trims

  • Leave the expansion gap under the trim; the trim covers it, the floor still floats.

  • T-mouldings and reducers sit on a metal or plastic track screwed to the subfloor, or are glued along one side only; never glue both floors to the trim.

  • Cut trims with a fine-tooth saw or drop saw; a mitre where two trims meet at a corner.

  • Undercut door jambs and architraves so the floor slides under them; a trim is for the floor change, not for hiding a gap at the jamb.

05

One floor, no trims

The best doorway is no trim at all. If you run one hybrid floor through the whole house, the only trims are at the front door, the garage and the wet-room tiles. It's one of the reasons we suggest hybrid for the whole home rather than laminate in the bedrooms and hybrid in the kitchen; see living room flooring.

Scotia · Underlay · DIY flooring guide

06

Trim questions

What trim goes between hybrid flooring and tiles?

 

A T-moulding if they're level, a reducer if the hybrid is higher.

 

What trim goes between hybrid flooring and carpet?

 

A reducer, stepping down to the carpet. The carpet's gripper strip sits beneath it.

 

Do I need a trim at a sliding door?

 

Yes, an L-moulding (end cap) gives a clean finished edge at the track.

 

How long are flooring trims?

 

2.4 metres, which does two standard doorways.

 

Can I avoid trims altogether?

 

Run one floor through the whole home. Then trims are only needed at exterior doors and wet-room tiles.

bottom of page