Flooring Transition Strips Explained: T-Moulding, Reducer, End Cap and Stair Nosing
Quick answer: Use a T-moulding where two floors of the same height meet, a reducer where your new floor steps down to a lower floor like tiles or concrete, an end cap (L-moulding) where the floor finishes against something higher like a sliding door track, and stair nosing on the front edge of each step.
Why you need transition strips
Floating floors like hybrid and laminate need a small gap wherever they finish, so they can move a little with the seasons. A transition strip covers that gap neatly and gives you a smooth, safe step from one floor to the next.
Which strip goes where
T-moulding: between two floors at the same height, such as a doorway between two rooms or where your hybrid meets existing timber.
Reducer: where your new floor is higher than the floor next to it, such as hybrid meeting tiles, vinyl or a concrete patio step. It slopes down so there's no trip edge.
End cap (L-moulding): where the floor stops against something fixed, such as a sliding door track, a fireplace hearth or a raised tiled area.
Stair nosing: wraps the front edge of each step for a clean, durable finish. See hybrid flooring on stairs.
Scotia: along the walls, covering the gap at the skirting. See how to fit scotia trim.

How to choose the right one
Check the heights. Same height on both sides: T-moulding. New floor higher: reducer. Floor stopping at a wall, door or hearth: end cap.
Match the colour to your floor. Our trims are colour-matched to our hybrid and laminate ranges, so they blend in.
Measure each doorway or join and allow one length per doorway. Trims come in long lengths you cut to size.
Follow your floor's installation guide for where expansion breaks are needed in long runs and large rooms.

Read more
Next steps
Order up to 3 free samples and see them in your own light.
Book a free measure and quote if you'd like us to install. Installed prices come from a free measure and written quote.
See every colour-matched trim on our transition strips and trims page.



Comments